• IRIG-A, IRIG-B, NASA36 timecode reader
• IRIG-B timecode generator
• IRIG-B output
• Optional GPS synchronization
• Time-Tag input
• Freewheel capability
• Programmable start/stop time output and interrupt capability

The TPRO/TSAT-PC104 performs timing and synchronization functions referenced to an input timecode signal. The board synchronizes its on-board clock to the incoming timecode. The on-board clock’s time is also provided as an IRIG-B output. Other features include a time-tag TTL input, a programmable “heartbeat” pulse or squarewave output (with interrupt capability), and a programmable “match” start/stop time output (with interrupt capability).

The board continues to increment time (“freewheel”) in the absence of an input timecode. Thus, the board can be used as an IRIG-B timecode generator by setting the inital time via the bus.

The input timecode format (IRIG-B, IRIG-A or NASA36) is automatically detected. Synchronization to the input timecode is also automatic and can be enabled/disabled via the ISA bus. The TSAT-cPCI can also obtain its time from a GPS antenna/receiver package. In either case, a propagation delay offset may be specified to compensate for cable delays.

The timecode input is an amplitude modulated sine wave. An automatic gain control (AGC) circuit permits a wide range of input amplitudes. The timecode input is differential; the board does not reference this signal to ground. A single-ended input (referenced to ground) is also acceptable.

The board can be ordred with option “–M” to synchronize to a one-pulse-per-second (1 PPS) input instead of an incoming timecode. In this case, the initial time is programmed via the ISA bus, and the board begins counting on the next 1 PPS pulse.

PC104 Interface
The board occupies 16 consecutive addresses in I/O (not memory) space. Jumpers on the board allow for selection of base address and the interrupt level. All board functions can be used without interrupts, if desired. All board functions can be accessed using 8-bit transfers. In addition, the time can be read with four 16-bit transfers. Binary-coded decimal (BCD) format is used for setting and reading the time.

 2 versions of the PC-104 timing board are available for new installations.

• TPRO-PC104 synchronizes its on-board clock to an incoming IRIG signal.
• TSAT-PC104 can also synchronize to GPS through its included GPS receiver/antenna package with 100' of cable. Also includes PVC vent pipe mast and metal straps. Also compatible with the 8213 flat-roof antenna mount.

Datasheets

TPRO-PC104 Timecode Reader-Generator

TSAT-PC104 GPS Timing Board

Manuals

Product Operating Manuals

• Windows 7, Vista (32-bit)
• Windows 2000/XP
• Windows NT
• Linux supports Kernals 2.4.x and up to 2.6.18 (32-bit)